Dell Inspiron 1520 keyboard latch to remove?

* 1. Turn the laptop upside down, the face of your hinges, then remove the Dell Laptop Keyboard, push the left under the battery in the laptop battery latch at the top right part. Slide the battery latch can cause the battery to pop the battery slot, at this point, you can lift and pull the battery slot.

* 2. Remove the hard drive. Along the right side of the notebook below the battery Remove the two screws (not in the deep hole), then grip the screw between the two grooves in the hard drive and pull the right to remove the hard drive it.

* 3. Lower left corner to eliminate the battery remove the screw located just below the optical drive. Use a screwdriver to push, you just deleted to the left, which causes a prominent part of the drive screw is located from the computer next to the gap. Handle the drive, and it "left to delete.

* 4. Remove the plastic cover below the battery (bottom of the laptop is only a plastic cover). Remove the two screws, then lift the plastic cover.

* 5. At the same time pushing the metal on both sides of each memory module folder, remove the memory modules apart from each other . This will result in the memory module pops up a point. The module from the slot to remove it.

* 6. Remove the memory module at the bottom of the same space (the plastic cap) of the modem.
In the lower right corner of the space of a single screw and pull out the left side of the rectangle from the cable modem disconnect the modem. Space elevator modem, remove it.

* 7. Remove the remaining 15 screws from the bottom of the laptop. There are four along the top edge, four along the bottom edge of your hard drive two screws, the battery latch to the right, left sides of a plastic cover you remove the two memory modules, and one about 2 ", screw the left side.

* 8. Remove the two screws on the back of notebook computers (either end). The back of the laptop is hinged on the side. In addition, remove the blue trapezoid using the VGA connector on both sides of two hexagon hexagonal screwdriver screws.

* 9. Open wide screen, as it will go, then insert the right side of the hinge between the lid and the laptop to go flat-bladed screwdriver to pry the hinge cover. Pull the hinge cover from the left side of the right to remove it. Hinge cover plastic piece on the power button. Dell Inspiron 1520 which is above the keyboard.

* 10. Remove the DELL Inspiron 1520 Keyboard, unscrew the top of the "F4" and "pause" button, then lift up slightly. Lift the keyboard latches located under the space bar, then the keyboard cable connector. Lift the keyboard, remove it.

* 11. Removed in the following right hinge on the right side of the notebook computer mini - PCI card. Larkin is black and white cable connector is disconnected. Pull card, remove from the laptop.

* 12. Remove the display. Unscrew the single screw on each hinge. Pull up the top space in the laptop mini - PCI card, pull the left side. Lift the monitor, delete it.

* 13. Remove the palm rest. Pull the connector off the touchpad. DELL Inspiron 1420 touch pad interface is located on the right of the DELL Inspiron 1420 keyboard connector. Pull standby switch connector at the top right of the mini - PCI card for the next. Loosen the top center of the laptop's single screw. Lift the palm rest, use your fingers to separate from the bottom of the laptop.
* 14

Remove the fan. Laptop fan in the upper left corner. There is a screw in the upper left and lower right corner of the need to be removed. Pulling on the connector cable to the fan disconnect the lower right corner screws on the right. Lift the fan removed from the laptop.

* 15. Remove the cooling components and processors. Unscrew the four screws, brass square cooling Assembly adopted it. Screw marked 1-4. They screw in numerical order, and then lift the cooling Congress, to remove it. Use flat head screws, remove the screws below the cooling your processor under the General Assembly. Turning the screw counterclockwise until it stops. Lift the processor, remove it.

* 16. Removing an ExpressCard slot. ExpressCard is in the middle right side of the laptop. Unscrew the three screws along the top slot, two on the left, and a slot in the lower right corner. Elevator ExpressCard slot, remove it.

* 17. Removing the system board. Remove the top left corner of the green board in the bottom left corner of the single screw single screw. Lift the bottom of the laptop motherboard case to remove it.

Tip:

* Unless otherwise noted, all screws need a Phillips screwdriver.
* Touch a piece of metal before contact with internal components to prevent static shock damage. In addition, open the laptop manufacturer's warranty.