How you can Display Nissan Patrol Fault Codes

The fault codes inside a Nissan Patrol are saved within the memory from the vehicle's powertrain control module (PCM). The PCM stores a code if this senses an issue with a number of from the vehicle's components like the ignition or transmission. An automotive scan tool attached to the Patrol's 16-pin diagnostic data port can be used to gain access to the fault codes saved within the PCM's memory.

1

Park the automobile on the flat working surface put the transmission gear change lever in to the "P" position. Switch off the engine and apply the parking brake. Turn the ignition to the "On" position. Don't start the engine.

2

Locate the 16-pin diagnostic data port. It's mounted beneath the dashboard around the driver's side from the vehicle, just beneath the steering column. Connect an VOLVO Diagnostic Tool data cable towards the 16-pin diagnostic data port.

3

Switch on the scan oral appliance take as well up. Choose "PCM" in the scan tool's primary menu. Choose "Codes" in the PCM sub-menu. Choose "Read All Current and Saved Codes" from codes sub-menu.

4

Write lower all the codes the Launch CReader VI tool shows and reference them utilizing an automotive repair manual specific towards the Nissan Patrol.